Vexilar FL-22 User Manual download pdf (Page 30)

A unique battery fuel guage

that recognizes both the

discharge and charge cycle

of your battery. It will sense

the current charging condition

of the battery, display the

percentage of remaining

capacity and display a

charge trend arrow...

( or ).

The D-130 will continue to measure capacity and

trend as long as it is connected to the battery.

When an additional “load” is applied to the

battery, the capacity will decrease according to

the load applied.

When the load is removed the digital readout

will remain at the last shown level and the trend

arrow will switch to ( ). This rebound indicates

the battery is starting to recover, but the digital

readout of the capacity will hold at its lowest

level unless you reset it by disconnecting and

reconnecting the D-130 to the battery.

*If you continue to use the D-130 without disconnecting it, the D-130 will show the last capacity until the battery

falls below this point, then continue to decline with use.

When a charger is attached to the system, the digital readout of capacity will remain the same, up

to an hour, with an ( ) arrow indicating that it is receiving a charge before the digital readout will

start to advance. Note, with some batteries, the very top rating for a charged battery (12.7 volts)

or 100% rating will not stay at 100% even though it might be fully charged. This is normal.

Each battery charges differently and may be fully charged but reads 95%, instead of 100%. This

is a normal occurrence with batteries since not all batteries will hold the same top-end percentage

when fully charged and is not an indication of a poor or defective battery.

When you reconnect the D-130 to the battery, the display will show the current status of the battery

at that moment. Note that the D-130 needs to be connected to the battery before a charger is

connected to give an accurate reading.

GREEN LED

100% to 75% Zone

YELLOW LED

75% to 50% Zone

ORANGE LED

50% to 25% Zone

RED LED

25% to 0% Zone

ON LED

Power is connected. If no other LEDs are illuminated,

the voltage is very low.

Battery Status Indicators

D-130 Digital Status Indicator T-130 LED Status Indicator

IMPORTANT: The T-130 will not show an accurate

level when the charger is connected. Remember to

use the charger's LED as your "Charge Complete"

indicator. Also, the percent of charge shown will

vary with the temperature and battery load.

Readings will be most accurate when the asher is

running and the temperature is above 50° F.

IMPORTANT: Be sure the indicators are not on during long storage periods, as excessive

battery drain can result. For Pro Pack systems, disconnect the indicator from the battery

before storage. For Ultra Pack systems, be sure the master power switch is off.

T-130

D-130

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

Comments to this Manuals

No comments

Vexilar FL-22 User Manual Page 30

Comments to this Manuals

Related products and manuals for Sports and recreation Vexilar FL-22