Vexilar LC-10 User Manual download pdf (Page 7)

may need to purchase

the optional Tri-Cup

bracket shown in figure

ALTERNATE

TRANSDUCER

MOUNTING

If you choose not to use the suction cup mounting

method, you can permanently mount the transducer to

your boat. This can, often, give better results, but you will

lose the portability of the transducer.

TRANSOM MOUNTING

The LC-10 transducer can be mounted, permanently,

on the transom of the boat. Proper installation will allow

a clear depth reading at any boat speed. Attach the angle

bracket to the transducer (flat edge facing forward). Locate

a spot at the bottom of the transom that is clear of ribs and

rivets that would be just in front of the transducer. Hold it

up to the boat. Mark the first hole on the transom, or mount-

ing plate, so that when the bottom of the transducer is flush

with the bottom of the boat, the hole is located at the bot-

tom of the bracket slot. This gives you room to "fine tune"

the position of the transducer and optimize your reading

after you've put the back boat in the water.

Figure 6

1 2 3 4 5 6 7 8 9 10 11 12 ... 27 28

No comments

Vexilar LC-10 User Manual Page 7